08-013-21

Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates This bulletin involves reprogramming the HCP and AHCP or also known as Power Inverter Module (PIM) with the latest available software. Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states.Customers may also experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set:P2797-00 - Auxiliary Transmission Fluid Pump Performance. P0CF3-00 - Control Pilot Circuit Open. P0A44 - Drive Motor A Position Sensor 1 Circuit Overspeed. U0111-00 - Lost Communication With Battery Energy Control Module (BPCM). P1625-00 - Park Pawl System Failure. U0412-00 - Invalid Data Received From Battery Energy Control Module-A. P215B-00 - Vehicle Speed Output Shaft Speed Correlation. P079A-00 -Transmission Friction Element 1 Slip Detected. P079B-00 - Transmission Friction Element 2 Slip Detected. Customers may also comment:Vehicle will not start when temperature is -30° C (-22° F) and below. Heard and/or felt bump when the gas engine turns on while driving. Vehicle will not charge beyond 98%. "Service Charging System" and "Traction Battery Cutoff" warning messages appear during a key cycle event at -7° C (-20°F). Vehicle will force to Park when keyed off in Neutral if the door is open during wake-up procedure and remains open or within 2 minutes of door closure. Loss of PSA when ignition push-button is pressed by driver after a Remote Start. Unusual battery drain when DTC, P084F-00 - Park-Neutral Switch Output is set. This software release includes the following software enhancement:Corrections to allow the vehicle to clear the permanent fault codes.