Startseite18-063-24 · JEEP
JEEP

18-063-24

Herstellerinformationen

Veröffentlichung
2024-07-25
Bei NHTSA eingegangen
2024-07-30
NHTSA-Datensatznummern
11005321

Herstellerzusammenfassung

Englischer Originaltext

"Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs):
• P06DD - Engine Oil Pressure Control Circuit Performance/Stuck Off.
• P00F3 - Humidity Sensor Circuit Range/Performance. Customer may also experience one or more of the following:
• Customers may experience coasting complaints at lower speed.
• Undesirable vehicle drivability behavior causing a vehicle Shift to Park event during Engine Stop Start (ESS) while Adaptive Cruise Control (ACC) is active.
• Pressing ACC button while ESS active can shift the vehicle to park.
• Idle speed oscillations observed when in Snow and Mud modes.
• Poor engine performance (undershoots engine speed) for ESS and for non-ESS engine start.
• Screen two incorrectly pops up on the Instrument Cluster Panel (IPC) for 5 seconds during Terrain and Rock mode. This bulletin involves reprogramming the PCM with the latest available software."

NHTSA-Herstellerinformationen ↗

Codes im Original

Wortlaut des Herstellers

Wortlaut kann nach Fahrzeug und Suffix variieren; keine universelle Diagnose.

Fahrzeugzuordnung prüfen

Eine Fahrzeugzuordnung ist ein Recherchehinweis. Motor, Produktionszeitraum und Software anhand der Herstellerangaben prüfen.

MarkeModellModelljahr
JeepGRAND WAGONEER2024
JeepWAGONEER2024

Datenabdeckung →