NISSAN
NTB18-016
Herstellerinformationen
- Veröffentlichung
- 2018-02-27
- Bei NHTSA eingegangen
- 2018-03-26
- NHTSA-Datensatznummern
- 10130502
Herstellerzusammenfassung
Englischer Originaltext
2018 PATHFINDER; MIL ON WITH DTC P34A5, AND/OR P34A9 STORED IF YOU CONFIRM MIL is ON with one or both of the following DTCs: -P34A5 (A camshaft posi actuator temp sens B1) -P34A9 (A camshaft posi actuator temp sens B2) And Outside ambient temperature was near or below freezing (32°F) when the DTCs were stored. NOTE: If any VTC DTCs other than P34A5 and/or P34A9 are also stored (example: P0011, P0021), those DTCs should be diagnosed and resolved first. ACTION Replace the electric intake valve timing control module (see Figure 1 on Page 2). -Electric intake valve timing control module is listed in the Parts Information of this bulletin. -Refer to the Electronic Service Manual (ESM), section ENGINE > ENGINE CONTROL SYSTEM, for replacement information. -Make sure to perform Electric IVT Control Actuator Position Learning after replacement of the module.
Codes im Original
Wortlaut des Herstellers
Wortlaut kann nach Fahrzeug und Suffix variieren; keine universelle Diagnose.
Nissan
P34A5A camshaft posi actuator temp sens B1Nissan
P34A9A camshaft posi actuator temp sens B2Fahrzeugzuordnung prüfen
Eine Fahrzeugzuordnung ist ein Recherchehinweis. Motor, Produktionszeitraum und Software anhand der Herstellerangaben prüfen.
| Marke | Modell | Modelljahr |
|---|---|---|
| Nissan | PATHFINDER | 2018 |