AUDI
Коды в оригинале P060600
This TSB states to follow GFF in instances when DTC P0ED02 is logged then check the diagnostic address for DTCs P0A1F00, P060400, P062F00, P060600, P061000, P151A00.
ГлавнаяP0606 · Материалы производителя
P0606 · Материалы производителя
Формулировки зависят от машины и суффикса, это не универсальный диагноз.
AUDI
Коды в оригинале P060600
This bulleti provides information when tehre is a drive system fault; DTCs P060600, P060C00, PA0F00.
AUDI
Коды в оригинале P060600
This Pending Service Solution requests that a PSS record be created when the MIL Drive System: Fault is stored in the ECM with DTC P06C00, P060600, or P0A0F00.
AUDI
Коды в оригинале P060600
This bulletin contains instructions for clearing DTCs P023600 and P060600.
AUDI
Коды в оригинале P060600
This bulletin contains instructions for clearing DTCs P023600 and P060600.
AUDI
Коды в оригинале P060600
Customer may report that the transmission warning light comes on. There are no drivability/starting concerns. DTC P060600 is stored in the TCM. The entry is caused by an overly sensitive diagnosis in the transmission…
AUDI
Коды в оригинале P060600
Supersedes Technical Service Bulletin Group 37 number 13-95 dated February 26, 2013. Customer may report that the transmission warning light comes on. There are no drivability/starting concerns. DTC P060600 (Control…
AUDI
Коды в оригинале P0606
Gearbox warning light briefly comes on. Fault code P0606 stored in TCM
AUDI
Коды в оригинале P060600
Supersedes Technical Service Bulletin Group 37 number 13-89 dated February 11, 2013. Customer may report that the transmission warning light comes on. There are no drivability/starting concerns. GFF scan shows fault…
AUDI
Коды в оригинале P0606
Gearbox warning light briefly comes on. Fault code P0606 stored in TCM.
AUDI
Коды в оригинале P060600
Supersedes Technical Service Bulletin Group 37 number 12-61 dated August 20, 2012. Customer may report that the transmission warning light comes on. There are no drivability/starting concerns. GFF scan shows fault code…